Made specifically for the gas block pin.

Set of 3 punches

1)Starter punch .078" tip

1)Hollow end starter punch .082" hole

1)Long nose punch .078" shaft

Made from high grade O1 tool steel that has been
heat treated and tempered.

Made in USA

Starter punch has a .078" diameter short tip
for breaking the pin free. After the pin is
loosened up use the long nose punch to finish
driving it out.

Install the pin using the hollow end punch. The hollow
end punch was designed for a tight fitting new pin.
If the pin you will be using is new it will require a light tap to insert
it into the hollow end punch. After the pin is started
use the short tip starter punch to finish installation.